Monokote + Heat
If you are applying monokote to a structure with a complicated surface, chances are you will have an uneven application sooner or later. When this happens and one area is not as taught as the others, or even has a bit of “puffyness” in extreme cases, you can tighten it up with an application of heated air. Word to the wise though, if your heat is concentrated in a small area, you are at risk of a spot burning though very quickly. I had a test wing segment that had a bit of sag around the leading edge, so I applied some heat from a butane lighter with excellent results – right up to the point where it melted a dime-sized hole!
Monokote + butane lighter you ask? Surely I should have known better? But ofcourse! That is what experimentation and improvisation is all about.